In addition to the installation instructions
these steps are provided.
1. Remove the paper from the adhesive and install the B-14
bracket so that the hole is over the screw. The angle of the bracket should
be about level. The kick back can be in or out of the guard but the knob
should be tight.
2. Install the laser guide per the alignment instructions.
3. Attach the switch to
the top of the guard.
4. Attach one cable clamp to the blade guard as shown
5. With the saw in the back position find a point about
1/3 the way down the slide to mount the second cable clamp. Hold the wire
by hand and move the saw from front to back to make sure the the cable
is not stretched tight. Attach the cable clamp to this position.
6. Use the cable ties to attach the Laserkerf power cable
to the saw power cable. |
