 |
 |
 |
 |
|
 |
|
|
| FREE SHIPPING - On orders over $300 - Applies to UPS Ground Only (No Common Carrier) - Click here for details |
|
|
|
|
|
|
|
|
|
| FREE SHIPPING - On orders over $300 - Applies to UPS Ground Only (No Common Carrier) - Click here for details |
| Dewalt 770 RAS laser guide installation | |
| In addition to the installation instructions these steps are provided.  1. Remove the paper from the adhesive and install the B-14 bracket so that the hole is over the screw. The angle of the bracket should be about level. The kick back can be in or out of the guard but the knob should be tight.  2. Install the laser guide per the alignment instructions. 
3. Attach the switch to the top of the guard. 4. Attach one cable clamp to the blade guard as shown 5. With the saw in the back position find a point about 1/3 the way down the slide to mount the second cable clamp. Hold the wire by hand and move the saw from front to back to make sure the the cable is not stretched tight. Attach the cable clamp to this position. 6. Use the cable ties to attach the Laserkerf power cable to the saw power cable. |
|
| Laserlevels.net Number One Source for Laser Levels and Accessories | ||||||
|
||||||
| Laserlevels.net Featured Laser Product Lines |