|
|
FEATURES
INSTANT ALIGNMENT
The standard practice of placing wood on a miter saw and
cutting is as follows
1 Place the wood on the table so that the cut mark is over
the slot
2 Bring the blade down to see if it hits the mark. This
works best if the mark happens to be in a position where the blade touches
the wood.
3 Apply power to the saw and make a very light cut
4 Now that you know where the blade is actually hitting
the wood you move the wood slightly to make the final alignment.
5 You now make the final cut.
| The
Laserkerf Method of cutting
|
| The laser is on so when
you take to wood to the table you set it in place, (using either side
of the beam) aligned with the edge of the beam. |
|
| Then cut |
|
It can't get any easier than that
|
